J2534 First timer

[evancoger]

So I just bought a j2534 pass through and have a 2005 pt cruiser that will need the pcm replaced. Im fine with programming the pcm but thinking on the key code programming, will I be able to do that too? Ive worked for GM and have done them all using a tech II, but this is the first time I will be doing something like this. Any help and tips are greatly apprecitated! Thanks

[Gonzo]

Some of the J2534 application will do the SKIM, that is if there is a heading for it. Basically it should (mine does) You'll need to call the dealership parts dept. with the VIN. Ask them for the SKIM code. This is the code that you'll need to enter. It's different for each car.

 

Of course there's more...there's always more with Mopar. You also have to enter the VIN into the new PCM and you'll have enter the tire/ratio in it as well. Some models you don't need the ratio but for most Chrysler products you do. Without it either the speedo won't work or the ABS light will come on after you drive the car on a couple of trips, (I think its 3 drive cycles) It will ask for the tire size basically and rear end ratio. (Parts dept. will have that too)

 

After you have a successful completion, clear all codes, remove the key for a few seconds and restart.

 

 

 

Hope that helps. Happy programming

[evancoger]

Thanks for clearing that up!